drivers: flash_stm32h7: fix flash size detection

Commit 0e41b07 ("drivers : flash:
update way to get flash size") changed the way to get flash size from
the LL_FLASH_GetSize() HAL function to the current DT_REG_SIZE() macro.

However, they are not equivalent:

- With LL_FLASH_GetSize(), REAL_FLASH_SIZE_KB returned the *total* size
  of the Flash memory, reading it from a ROM register of the CPU. For
  example, it was 2048 (2MB) for a STM32H747xI.

- The current DT_REG_SIZE() applies to a flash *bank*, therefore it only
  returns half of the total Flash size on dual bank devices.

This mismatch causes issues with the DISCONTINUOUS_BANKS logic below,
incorrectly matching partitions close to the end of the first bank as
appearing to span both and triggering the "range overlaps discontinuity"
check later.

Fix it by doubling the size when appropriate, in the same way it is
already done for the M4 core.

Signed-off-by: Luca Burelli <l.burelli@arduino.cc>

Author: pillo79

drivers/flash/flash_stm32h7x.c

@@ -45,8 +45,12 @@ LOG_MODULE_REGISTER(LOG_DOMAIN);
 #define REAL_FLASH_SIZE_KB (KB(STM32H7_M4_FLASH_SIZE * 2))
 #endif
 #else
+#if defined(DUAL_BANK)
+#define REAL_FLASH_SIZE_KB (DT_REG_SIZE(DT_INST(0, st_stm32_nv_flash)) * 2)
+#else
 #define REAL_FLASH_SIZE_KB DT_REG_SIZE(DT_INST(0, st_stm32_nv_flash))
 #endif
+#endif
 #define SECTOR_PER_BANK ((REAL_FLASH_SIZE_KB / FLASH_SECTOR_SIZE) / 2)
 #if defined(DUAL_BANK)
 #define STM32H7_SERIES_MAX_FLASH_KB KB(2048)